Size Guide

Ring Size

You can get your ring size by measuring your existing ring or your finger.

To measure existing ring:

  1. Choose a ring that is the best fit for your finger.
  2. Measure the inner diameter of the ring.
  3. Determine the ring size using the chart below (refer inside diameter).

To measure your finger:

  1. Wrap a measuring tape, paper or string around the base of the finger that you want to wear the ring on.
  2. Make sure the strip is wrapped tightly around your finger, then use a pen to mark the spot where it overlaps.
  3. Measure the length of the paper up to the marked point with a ruler, then compare your reading (in mm) to the ring size chart below (refer inside circumference). 

Please note that fingers contract when cold and expand when hot, so you will need to adjust the size according to the temperature. Sizes may vary between half to one size under different temperature conditions. To find the best fit, make sure that you are able to rotate your ring comfortably so that it will not fall off easily during cold temperature and will feel slightly tight during hot temperatures. 

*Please round your circumference measurement to the nearest whole number. For example, if your circumference measurement is 47.8mm, please refer to the sizing for 48mm.
*For inside diameter, please refer to the sizing that is closest to your measurement. 

Inside Circumference (mm)
Inside Diameter (mm)
EU Size (Aluminum Finger Sizing Measuring Stick)
45
14.3
5
46
14.6
6
47
15.0
7
48
15.2
8
49
15.6
9
50
15.9
10
51
16.2
11
52
16.6
12
53
16.9
13
54
17.2
14
55
17.5
15
56
17.8
16
57
18.1
17
58
18.5
18
59
18.8
19
60
19.1
20
61
19.4
21
62
19.7
22
63
20.0
23
64
20.4
24
65
20.7
25


Necklace Length Guide

Most of our necklace is connected with a 5cm extension chain. A necklace extension chain gives you the flexibility of changing the length to wear your necklace, so you can get the exact length you want.
Do refer to the product description section for the exact measurement of the item.

Wrist Size

  1. Using a flexible measuring tape, measure the circumference of your wrist, where you would normally wear your bracelet, as shown in the diagram below. Start from "0" cm.
  2. Read your exact wrist measurement. We will provide the right allowance based on our standard wrist patterns.
  3. For example, if your wrist is 15.5cm, please round to the nearest whole number and select 16cm at the product page.
  4. We will provide precise measurement and proper fitting. Please take note that we can only ensure proper fitting with correct measurement provided.

If you do not have any measuring tape, you may use a paper strip or string.

  1. Measure your wrist using a strip of paper or string. Mark your strip with a pen where the ends of the strip meet.
  2. Then, measure the paper strip or string with a ruler starting from "0". This is your wrist size.